Chicago Pneumatic CPXHT25
High Temp Refrigerated Dryer / 7.5-HP / 25 CFM /115V Single Phase / Use with compressors up to 7.5-HP
The CPXHT-25 model air dryer from Chicago Pneumatic is the answer to moisture-free air for your 5-7hp air compressor. Providing clean, dry air has never been easier and with its low maintenance and quick installation the CPXHT-25 is the perfect solution for any shop. Quiet-running, this unit eliminates noise pollution – a perfect match for a QRS (Quiet Rotary Screw) air compressor. Eliminate water, oil and dirt from your air systems with the Chicago Pneumatic CPXHT-High Temp Dryers to increase profitability and productivity.
Keep Water, Oil, And Dirt Out Of Your Compressed Air •Less corrosion of pipes and tools means less downtime •Avoid "fisheye" paint splotches and oil stains on your projects Easy To Install •115 Volt power means no special wiring •Maximum inlet temperature of 180°F; no aftercooler required Space Saving Design Is Quiet And Efficient •Air-cooled after cooler, refrigerated air dryer •Moisture seperator, electronic water drain, coalescing filter •Easy to read control panel; 1/2" NPT connection Increases Productivity And Profitability •Fewer finished product defects •No need to keep purging your air lines Wide Range Of Applications •Maximum ambient 95°F; Minimum ambient 40°F •Dew Point Temperature 50°F +/- 2°F •Use with up to 7.5 horsepower air compressors •Copper heat exchanger uses R-134a refrigerant |
Model Number: | CPXHT25 |
Manufacturer: | Chicago Pneumatic |
Overview | |
Dimensions: | 14L x 15W x 19H |
Product Weight: | 57 lbs (26 kilograms) |
HP Rating: | 7.5 HP |
CFM Rating: | 25 |
Max Inlet Rating: | 180 |
Max Ambient Rating: | 95 |
Regenerative: | No |
High Temp: | Yes |
Non-Cycling: | No |
Inlet Fittings: | 1/2" |
Outlet Fittings: | 1/2" |
Aftercooler: | No |
Pre-Filter: | No |
Post-Filter: | No |
Wall Mountable: | No |
Alarm Lights: | No |
Auto Drain: | Yes |